MetroTherm Agriculture 200-300 E

MetroTherm Agriculture 200-300 E

When choosing the make and water heater for your milk room, consider the following:

All types of stainless steel boilers, regardless of make, should not be installed where the chloride content exceeds 50 mg/l, or in calcareous water.

As standard, all boilers are equipped with an "agricultural thermostat" and a hot water outlet that provides approx. 90°C tap water compared to 65°C for a normal boiler, all for a safe dish. There is also always an outlet for tempered water for connection of e.g. wash basins and sinks.

Always choose a processor that is slightly too large, the need can quickly change on the farm, for example in case of changed milk collection times, different calving, intensity etc.

Consumption of electrical energy is dependent on the water withdrawal and not on the size of the boiler, the maintenance energy is relatively low.

If you need more than 300 litres, it is better with 2 pcs. series-connected generator than a large generator.

Construction

The water tank consists of enamelled pressure vessel steel which provides the highest corrosion resistance. The construction is pressure tested at 13.5 bar and approved for a maximum operating pressure of 10 bar.

Heating element in protective tube - withstands all water

The Sonett Cabinet, Modul and Agricultural series have indirect heating. The heating element consists of a heating coil. As the water does not come into direct contact with the heating element, the risk of power reduction is eliminated. The steel tube is mounted through a flange connection, easy to disassemble for inspection or cleaning.

Enamelled container with protective anode = extra safety

The METRO boilers have a special emapan enamel with the same expansion coefficient as the pressure vessel steel, which means that the enamel does not crack and thus exposes the steel to rust attack. The enamel layer is bacteria- and lime-repellent and resists all types of water. There are no metals that can affect the quality of the water. More than 50 years of experience is behind the special enameling technology. All enameled water heaters from METRO THERM have a protective anode. When enamelling, microscopic pores can appear which means that the water can come into contact with the steel surface. The anode sacrifices itself against the pores and covers them with magnesium.

Technical data

• Model        :200 E 300 E
• Power        :400 V 3000 W 3000 W
• Height        :1450 mm 1820 mm
• Width          :600 mm 600 mm
• Depth          :600 mm 600 mm
• Weight        :99 kg 122 kg
• Heating time to 8-88° at 400V 6.2 hours 9.3 hours
• Number of showers approx. 7-8 approx. 10

Guarantee

For the water heaters, METROTHERM provides a two-year warranty according to AA VVS -09, plus an additional two years on pressure vessels. The warranty only applies if the installation and care instructions have been followed and only for installation in Sweden. The warranty is not applicable outside Sweden. It is only valid when the unit is installed within Sweden.