Opus 200L LED, Straight, 230V, 13W, IP44, Black, IFÖ ELECTRIC 7501360
Watch this product and we will notify you once it is back in stock.
Opus 200L LED, Straight, 230V, 13W, IP44, Black, IFÖ ELECTRIC 7501360
Description
Installation: Insert the mains cable through the cable entry at the bottom. Fasten the luminaire to the wall or ceiling with suitable screws, making sure that the arrow and the text UP at the bottom of the base point upwards when wall mounting. Feed the cables up through the opening next to the terminal block on the joint module and then secure the joint module with the two supplied screws. Connect the conductors to the terminal block. Then screw on the cup by turning it clockwise. Make sure the gasket between glass and plinth is in place.
Technical information: Silicone seal between glass and plinth. Two Ø 6mm holes for mounting, CC dimension 133 mm, alternatively two hidden holes Ø 5 mm, for CC dimension 70 mm. A cable entry at the bottom with sockets for two mains cables. The connection terminal on the led module for max. 2 x 2.5 mm2. Over-connection is possible. Bottom penetration and three break walls. Pet protection and protection against splashing water from all angles.
Dimmer: The LED module can be dimmed with Triac dimmers that are specified with a minimum power of 20W. Transistor dimmers Elko 315 GLE and Schneider-Electric SBD315RC with a load of 20-315W work perfectly and are tested from one to a maximum of four connected modules.
Maintenance: Disconnect the power to the fixture. Unscrew the glass and clean it. Do not use cleaning agents that contain solvents. Replace joint module if necessary. Check the gasket and replace it if necessary. Put the glass on.
Characteristics
- Light source: LED
- Power: 13W
- Luminous flux: 950lm
- Color temperature: 3000K
- MacAdam 3 SDCM
- Lifespan: 50,000 h
- Ra (CRI): 80
- Dimmable: Yes
- Voltage: 230V
- Base color: Black
- Protection class: I
- Protection class: IP44
- Energy class: E
- Height: 100mm
- Diameter: Ø200mm
Specifications
- Nominal luminous flux: 1350 lm
- Color temperature: 3000 - 3000 K
- Protection class (IP): IP44
- Impact resistance (IK): IK02
- Number of poles: 2
- Bluetooth controlled: No
- Dimmer with push button: Yes
- Rear edge dimming (phase cut-off): Yes
- Dimming DALI: Yes
- Dimming DALI-2: Yes
- Dimming mains voltage modulation: Yes
- Dimming programmable: No
- Drive included: Yes
- Power light source: 12W
- Power light source multiwatt: Not applicable
- Power factor: 0.97
- Energy efficiency class light source (EU 2019/2015): E
- Flicker value: Pst LM 0.6
- Photobiological safety (EN 62471): RG1
- Color housing/casing/frame: Black
- Color fastness (McAdam ellipse): SDCM3
- Color rendering index (CRI/Ra): 90-100
- Glow wire test (IEC 60695-2-11): 650 °C - 30 s
- Filament tested according to IEC 60695-2-10: None
- Height/depth: 100mm
- Light flux adjustment: Infinitely adjustable
- Connection: Other
- Lamp holder/base: None
- Conductor area: 2.5 mm²
- Light colour: White
- Light distributor/scatter: Diffuser lens/optics/panel
- Light distribution: Symmetrical
- Light source: LED (replaceable)
- Light scattering angle: Open beam
- Light output: 112 lm/W
- Light outlet: Direct/indirect
- Suitable for lamp power: 12 - 12 W
- Suitable for ceiling mounting: Yes
- Suitable for surface mounting: Yes
- Suitable for wall mounting: Yes
- Suitable for wall mounting: Yes
- Appropriate number of light sources: 1
- Material housing/casing/frame: Porcelain
- Material Cup/Cover: Plastic (opal)
- Max. system power: 12 W
- With light source: Yes
- Rated voltage: 230 - 230 V
- Rated current: 52 - 52mA
- Nominal ambient temperature according to IEC 62722-2-1: -30 - 25 °C
- Ambient temperature: -30 - 25 °C
- Reflector: None
- Protection class: II
- Voltage type: AC
- Strobe power value SVM: 0.5
- Type of connection: Plug-in terminal (quick terminal)
- Type of wiring: Suitable for through wiring
- Type of light regulation: Other
- Type of surface: Glossy
- Surface protection housing/casing/frame: Glazed
- Outer diameter: 202mm